大断面小净距城市隧道洞口段穿越散岩堆积体施工技术

作者:姜以安 邹涛 彭雪峰 方勇 杨文波
单位:四川公路桥梁建设集团有限公司 西南交通大学交通隧道工程教育部重点实验室
摘要:以曾家岩北延伸段二标段火凤山隧道工程为背景,采用FLAC3D软件研究不同施工工法、开挖顺序对大断面小净距城市隧道围岩变形规律的影响。结果表明:散岩堆积体地层条件下,隧道开挖采用台阶法造成的竖向位移较大,CRD法开挖围岩变形较小。由于左线隧道埋深大于右线隧道,左线隧道各监测点竖向位移均比右线隧道大。隧道开挖顺序对围岩变形有明显影响,右洞先行开挖竖向位移最小,左洞先行开挖次之,同时开挖最大。
关键词:隧道工程围岩散岩堆积体监测施工技术
作者简介:姜以安,工程师,E-mail:898846582@qq.com;*杨文波,博士,教授,E-mail:yangwenbo1179@hotmail.com。
基金:国家自然科学基金(51678499)。 -页码-:55-58
尊敬的用户,本篇文章需要20元,点击支付交费后阅读
参考文献[1] 陈红旗,黄润秋,林峰.大型堆积体边坡的空间工程效应研究[J].岩土工程学报,2005(3):323-328.
[2] 李树武,聂德新,刘惠军.大型碎屑堆积体工程特性及稳定性评价[J].岩石力学与工程学报,2006(S2):4126-4131.
[3] 熊冰.某高速公路岩堆体特征及对路基工程影响分析[J].铁道工程学报,2014(1):49-52,58.
[4] 朱正国,朱永全,吴广明,等.泥石流堆积体隧道围岩加固及施工方案优化研究[J].铁道工程学报,2013(11):75-81,87.
[5] 张小明.堆积体大断面隧道进洞施工工法[J].铁道标准设计,2012(S1):130-133.
[6] 黄波.公路隧道软弱围岩开挖方法研究[J].土工基础,2004(5):59-61.
[7] 谢贵明.南华特长隧道堆积体进洞综合技术研究[J].工程技术研究,2017(3):7-10.
[8] 黄成林,罗学东,吕乔森.软岩隧道开挖方法对变形影响数值模拟研究[J].铁道建筑,2011(11):35-38.
[9] 王伟锋,毕俊丽.软岩浅埋隧道施工工法比选[J].岩土力学,2007,28(S1):430-436.
[10] 周强,黄永强.松散堆积体中浅埋小净距隧道施工期位移和应力场的2D分析[J].公路工程,2011,36(4):16-21,25.
[11] 李华,彭文波.超浅埋偏压小净距隧道的施工力学行为分析[J].路基工程,2016(3):213-217.
[12] 王春河,张爱军,樊祥福,等.上下台阶法和CRD法施工下超大断面隧道围岩控制机制数值试验研究[J].公路,2018,63(5):313-317.
[13] 陈智慧.大断面公路隧道洞口段穿越堆积体设计[J].铁道标准设计,2014,58(12):104-108.
[14] 徐军,郑颖人.隧道围岩弹塑性随机有限元分析及可靠度计算[J].岩土力学,2003(1):70-74.
[15] 高峰,谭绪凯.隧道围岩注浆加固效应模拟方法研究[J].铁道工程学报,2014,31(11):82-86.
[16] 郑军华,丁海洋,邱正华.弁山大断面隧道软弱破碎围岩加固技术[J].公路,2010(9):236-241.
Construction Technology of Urban Tunnel Entrance Section with Large Section and Small Net Distance Passing Through Loose Deposits
JIANG Yian ZOU Tao PENG Xuefeng FANG Yong YANG Wenbo
(Sichuan Road and Bridge(Group)Co., Ltd. Key Laboratory of Transportation Tunnel Engineering of Ministry of Education, Southwest Jiaotong University)
Abstract: Taking Huofengshan Tunnel of Section II of Zengjiayan north extension project as the background, FLAC3 D software was adopted to study the influence of different construction methods and excavation sequence on the deformation law of surrounding rock of urban tunnel with large section but small net distance. The results show that under the condition of loose deposits, the vertical displacement caused by the tunnel excavation is larger when using benching tunneling method, and smaller when using the CRD method. Because the left-line tunnel is deeper than the right-line tunnel, the vertical displacement of each monitoring point of the left-line tunnel is larger than that of the right-line tunnel. And the sequence of tunnel excavation has obvious influence on the deformation of surrounding rock. The vertical displacement is the smallest when first excavating the right hole, then is the excavating of the left, and the largest one is the simultaneous excavation of both the left and the right.
Keywords: tunnels; surrounding rock; loose deposits; monitoring; construction
839 0 0
文字:     A-     A+     默认 取消