消防泵启动若干问题探讨研究

作者：郭涛任建平李志鹏钱红艳

单位：北京特种工程设计研究院

摘要：较于先行实施的GB 50116-2013《火灾自动报警系统设计规范》,新版的GB 50974-2014《消防给水及消火栓系统技术规范》以及GB 50084-2017《自动喷水灭火系统设计规范》对消防泵启动方式都提出了新的要求。为使消防泵启动设计、安装调试既能满足规范要求,又能在实际工程应用中顺利通过消防验收,本文首先对消防泵主要启动信号的合理化应用进行剖析,指明现有启动方式存在的缺陷,并提出优化后的启动方案。分析通用消防泵控制图中延时控制与手/自动切换位置不合理,容易导致极端情况下消防泵无法及时启动的机理,并提出改进措施。

关键词：直接自动启泵联动控制火灾报警启动时间硬拉线

作者简介： 郭涛,本科,高级工程师,原设备室(水暖电)主任,E-mail:bryant_02@163.com。;

尊敬的用户，本篇文章需要1元，点击支付交费后阅读

限时优惠福利：领取VIP会员
全年期刊、VIP视频免费!

参考文献[1] GB 50084-2017自动喷水灭火系统设计规范[S]．北京:中国计划出版社,2017．

[2]GB 50116-2013火灾自动报警系统设计规范[S]．北京:中国计划出版社,2014．

[3]GB 50974-2014消防给水及消火栓系统技术规范[S]．北京:中国计划出版社,2014．

[4] 16D303-3常用水泵控制电路图[M]．北京:中国计划出版社,2016．

[5] 15S909消防给水及消火栓系统技术规范图示[M]．北京:中国计划出版社,2015．

[6] 14X505-1火灾自动报警系统设计规范图示[M]．北京:中国计划出版社,2015.

Discussion on Some Problems of Fire Pump Starting

Guo Tao Ren Jianping Li Zhipeng Qian Hongyan

(Beijing Special Engineering Design and Research Institute)

Abstract: Compared with Code for design of automatic fire alarm system( GB 50116-2013),the new version of Technical code for fire protection water supply and hydrant systems( GB 50974-2014) and Code for design of sprinkler systems( GB 50084-2017) put forward new requirements for fire pump linkage control. In order to make the fire pump start design,installation and debugging not only meet the requirements of the code,but also pass the fire inspection and acceptance in the practical engineering application,this paper first analyzes the rational application of the main start signals of the fire pump,points out the defects of the existing start mode,and puts forward the optimized start scheme. This paper analyzes the mechanism that the delay control and manual/automatic switch positions in the control chart of general fire pump are unreasonable,which is easy to cause the fire pump can not start in time in extreme cases,and puts forward improvement measures.

Keywords: direct automatic pump start; linkage control; fire alarm; start time; hard pull wire;

1864 12 12