石屑制备超高性能混凝土力学性能试验研究

引用文献:

翟雪强 ,李晓军. 石屑制备超高性能混凝土力学性能试验研究[J]. 建筑结构,2023,48(05):58-62.

ZHAI Xueqiang ,LI Xiaojun. Experimental study on mechanical properties of UHPC prepared by stone chips[J]. Building Structure,2023,48(05):58-62.

作者:翟雪强 ,李晓军
单位:西安科技大学地质与环境学院
摘要:使用破碎、筛分后的废弃石屑代替石英砂作为骨料制备超高性能混凝土(UHPC)。基于单因素分析试验,研究了各因素(水胶比、胶集比、减水剂掺量、钢纤维掺量)对石屑UHPC抗压强度、抗折强度及流动度的影响规律,考查了四种不同养生方式下石屑UHPC力学性能的变化。结果表明,当胶集比、水胶比、减水剂掺量、钢纤维掺量分别为0.63、0.2、2.1%和1.5%时,石屑UHPC的力学性能和工作性能最优,7d抗压强度最高为113.7MPa,抗折强度为35.2MPa;分析应力-应变曲线发现,掺加钢纤维不仅可以提高石屑UHPC的力学强度,还能显著提高石屑UHPC的韧性和残余抗压强度;经过水浴养护、干热养护和水浴+干热组合养护后,石屑UHPC的抗压强度分别提高了5.7%、27.1%和40.3%,但热养护对抗折强度影响不大。
关键词:超高性能混凝土;石屑;力学强度;流动度;养生方式;
作者简介:翟雪强,硕士,主要从事固废再生利用研究,Email:1944116417@qq.com。李晓军,博士,教授,主要从事固废再生利用研究,Email:554748566@qq.com。
基金:陕西省土地工程建设集团科研项目(DJNY2019-10)。
尊敬的用户,本篇文章需要2元,点击支付交费后阅读
参考文献[1] RICHARD P,CHEYREZY M.Composition of reactive powder concretes[J].Cement and Concrete Research,1995,25(7):1501-1511.
[2] 覃维祖,曹峰.一种超高性能混凝土——活性粉末混凝土[J].工业建筑,1999,29(4):18-20.
[3] 吕平,龙佩恒,何国顺.活性粉末混凝土性能试验及其在人行天桥改造工程中应用的研究[J].建筑结构,2020,50(S1):857-861.
[4] 王朋,李龙堂,丁耀宗.活性粉末混凝土耐久性研究综述[J].建筑结构,2019,49(S2):610-616.
[5] 谭世霖,杨医博,蒋雪琴,等.广东省石屑调查与性能分析研究[J].混凝土,2011(6):84-87.
[6] 欧伟豪,杨医博,郑炜金,等.高强石屑混凝土的试验研究[J].混凝土,2010(3):89-91,94.
[7] 赵明亮,黄赟,费洗非,等.石屑对混凝土工作性及强度的影响试验研究[J].混凝土与水泥制品,2019(7):4-8.
[8] 柴丽娟,李珠,季海峰.石屑代砂在玻化微珠保温混凝土中的试验研究[J].科学技术与工程,2015,15(29):189-192,198.
[9] 刘娟红,宋少民.活性粉末混凝土——配制、性能与微结构[M].北京:化学工业出版社,2013.
[10] 寇佳亮,刘云昊,张浩博.活性粉末混凝土力学性能及耐久性能试验研究[J].建筑结构,2018,48(2):48-54,47.
[11] 林剑,吴岳峻,高帅,等.养护温度对活性粉末混凝土孔结构的影响研究[J].硅酸盐通报,2019,38(8):2600-2605.
[12] 石常龙.养护制度对超高性能混凝土强度和韧性的影响[D].北京:北京交通大学,2018.
[13] 水泥胶砂强度检验方法(ISO法):GB/T 17671—1999 [S].北京:中国标准出版社,1999.
[14] 水泥胶砂流动度测定方法:GB/T 2419—2005[S].北京:中国标准出版社,2005.
[15] 刘娟红,宋少民.活性粉末混凝土——配制、性能与微结构[M].北京:化学工业出版社,2013.
[16] 白二雷,许金余,高志刚.EPS混凝土冲击压缩韧性研究[J].混凝土,2011(11):73-76.
[17] 郭鹏,程永刚.高温养护对活性粉末混凝土力学性能的影响研究[J].混凝土与水泥制品,2014(2):1-4.
[18] 牛旭婧,朋改非,尚亚杰,等.热水-干热组合养护对超高性能混凝土力学性能的影响[J].硅酸盐学报,2018,46(8):1141-1148.
Experimental study on mechanical properties of UHPC prepared by stone chips
ZHAI Xueqiang ,LI Xiaojun
(College of Geology and Environment, Xi'an University of Science and Technology)
Abstract: Use sieved granite chips to completely replace quartz sand as aggregate to prepare ultra high performance concrete(UHPC). Based on the single factor analysis test, the influence of various factors(binder-aggregate ratio, water-binder ratio, water reducing agent content, steel fiber content) on the stone chip UHPC compressive strength, flexural strength and liquidity was studied, and examined the changes in the mechanical properties of stone chip UHPC under four different curing methods were presented. The results show that when the binder-aggregate ratio, water-binder ratio, water reducing agent content, and steel fiber content are 0.63,0.2, 2.1% and 1.5% respectively, the mechanical properties and working performance of stone chip UHPC are best, the 7d compressive strength is 113.7MPa, and the flexural strength is 35.2MPa. Analysis of the stress-strain curve found that the addition of steel fiber can not only improve the mechanical strength of stone chip UHPC, but also significantly improve the toughness and residual compressive strength of stone chip UHPC. After water bath curing, dry heat curing and water bath + dry heat curing, the compressive strength of stone chip UHPC increased by 5.7%, 27.1% and 40.3% respectively, but thermal curing have little effect on the flexural strength.
Keywords: ultra high performance concrete; stone chip; mechanical strength; liquidity; curing method
552 0 0
文字:     A-     A+     默认 取消